Question

Hi everyone,

even on FMB640 and FMB641 as well, data from CAN00 to CAN09 are correctly sent to server. Instead the datas from CAN10 until the last can are ignored. The messages are correctly managed by server ckecking crc. Do I miss anything in the configuration?

Answer 1

Hello.

To read Manual Can elements higher than 9 (Manual CAN 10, Manual CAN 11.....), codec 8 Extended must be enabled, because those elements Ids are higher than 255, so they needs 2 bytes representation.

To enable Codec 8 Extended, go to System -> Protocol Settings -> Data Protocol in Teltonika configurator

Note, that your server must support codec 8 extended data.

Below, please find link with details:

https://wiki.teltonika-gps.com/view/Teltonika_Data_Sending_Protocols

Regards