Hello,
Thank you very much for your question.
The command format should be as follows: “setdigout ## Y1 Y2” where ##: 0-OFF, 1-ON for DOUT 1 and DOUT 2, respectively. Y1 and Y2: timeout for DOUT1 and DOUT 2, respectively. For example; the “setdigout 11 20 30” command will activate DOUT1 for 20 and DOUT 2 for 30 seconds.
Alternatively, you can also use the following format: “setdigout X Z Y” where X: DOUT#, Z: 1: activate, 2: deactivate, Y: activation/deactivation timeout. For example; the “setdigout 1 1 30” command will activate DOUT1 for 30 seconds.
You can refer to https://wiki.teltonika-gps.com/view/FMA_setdigout.
Please note: If the immobilizer feature is already enabled, this command will not overwrite the current DOUT state.
I hope this helps. I wish you a good day.
Best Regards,