Hello
All used setparam commands are for profile 3
Command structure: setparam #### #
Sets new value for parameter. ID consists of 4 digits – first digit identifies profile, second, third and fourth identifies parameter ID. In value field a new parameter value is entered.
Example: ‘setparam 1245 127.0.0.1’ will change configured IP address in profile1 with new value
Please check what is current device profile with getinfo command and look for P:# parameter in answer.
If, for example you will receive P:2 - this means that device is using currently profile 2, then you schould use setparam 2245 IP and so on.
Regards