You can check all the LV CAN parameters in the LV CAN Configuration window where you configure the program number and properties of each parameter.(Due to some error, I can't attach the screenshot here)
For that please do the below steps.
Connect FMB640 to LV CAN 200, wait for 10s (Note, that car engine must be started), disconnect LV CAN 200 from FMB640, and connect PC USB cable to FMB640 Device.
FMB640 remembers received data from LV-CAN200 and you can see all CAN data which is sent by LV CAN in the LV CAN tab highlighted as green color.
It is very important that not to disconnect FMB640 from power source during this operation, because if FMB640 is rebooted all received CAN bus data will be lost
Thanks in advance