Question

I'm looking to configure my FMB204's to wake and send data as soon as there is a change on the analog input, to give an "alarm" feature.

I've tried setting the Analog input 1 to "high" priority, operand "on change" but that doesn't seem to do what I was hoping.

The unit is set to deep sleep after 5 minutes.

Looking at the documentation this is by design, but just wondering if there is any way around this?

Thanks in advance

James

Answer 1

Hi, JamesM85.

The documentation says:

FMA2YX exits deep sleep mode when if ONE of following conditions are true:
* Movement by movement sensor is detected;
* Ignition (configured Ignition Source) is turned on;
* USB cable is connected

So, if you want to end deep sleep by signal, you can try to use Ignition DIN for that purpose. But it will mess with ignition-related functionality.

Comments

Thanks, I appreciate that's what the documentation says, I was just wondering if there was any way around that.

Thanks again

James