WIKIABOUT

FOR TIPS, gUIDES & TUTORIALS

subscribe to our Youtube

GO TO YOUTUBE

4167 questions

4739 answers

3460 comments

0 members

Most popular tags

fmb920 fmb120 configurator fmb640 sms-commands firmware fmb125 fmb001 configuration unlock-code fmb204 bluetooth canbus fmb140 fota-web fmc640 fmc130 firmware-upgrade fmb130 sms
We are migrating to our new platform at https://community.teltonika.lt. Moving forward, you can continue discussions on this new platform. This current platform will be temporarily maintained for reference purposes.

7696: sensors parameters (IO)

0 votes
897 views
in Vehicle tracking by anonymous
Hi, I use the GPS server platform to locate its objects. Currently, I am working on sensors and I have questions about the parameters that I have to send to FMB 120 GPS tags.for ignition ACC, what parameter "io" (io1, io67) do I have to configure on the server? for the automatic detection of the drivers, what parameter should I use? for the battery level, what parameter should I point to? as well as for the temperature?

1 Answer

0 votes
by anonymous

Hello,

Thank you for your question,

  • Battery voltage I/O AVL ID = 67 
  • Ignition status I/O AVL ID = 239 (This parameter defines if the ignition is on determined by ignition source settings)
  • Digital input 1 AVL ID = 1
  • iButton ID AVL ID 78 (This parameter is used to determine the iButton/RFID that is connected using 1-Wire, mostly used for driver authentification)

The list of I/O elements can be found in our wiki:

https://wiki.teltonika.lt/view/FMB_AVL_ID

Please make sure that parameter is enabled in the configurator (priority set to low/high/panic) so the information of I/O is sent to server.

Regards.