Question

Hello, I have a FMB120, is the accelerometer (sensivity) configurable? There are some command for that?
I have configured Accelerometer as Movemement source.

Kind Regards

Answer 1

Hello,

Thank you for your question.

For each vehicle accelerometer features can be set individually to achieve best accuracy results. For example if you will open configurator you will see some configurable parameters for accelerometer:

System> Accelerometer Delay Settings - this feature is used to delay event when it starts or stops. 

Movement Start Delay (s) / Movement stop Delay (s) - Movement Start/Stop Delay in seconds (This impact Ignition/Movement source)

Features > Eco/Green Driving

Max Acceleration/Max Breaking/Max Cornering - Value which can be reached while accelerating without triggering harsh acceleration event.

Source: Accelerometer - Which source data will be collected from.

Under each parameter you can set values to get accelerometer (sensitivity) configured. 

Information sources can be found in Teltonika Wiki page: https://wiki.teltonika.lt/view/FMB120_System_settings  & https://wiki.teltonika.lt/view/FMB120_Features_settings

Hope this will help,

Regards.

Comments

Hi , i have an mtb 100, i need information on how to configure accelerometer sensitivy.

i have to configure the sensitivity to enter and exit sleep mode.

I configured the online sleep mode, but measuring the absorption, it always remains at about 25ma

thanks to everyone

Regards

Leonardo

---

Try adjusting Movement start delay and stop delay. times in system tab.

Device goes to sleep mode after timeout will be reached when it is on stop mode. So accelerometer might be responsible for movement source and ignition source - these two sources tells if device can go to sleep

---

thanks for the reply.

the problem is that my accelerometer continues to signal a movement, I am attaching a report

as you can see, the ingnition is off, and the car is parked at home, but the accelerometer continues to trigger the motion.

Regards

Leonardo

---

Please increase start delay time: