subscribe to our Youtube


4167 questions

4739 answers


0 members

We are migrating to our new platform at Moving forward, you can continue discussions on this new platform. This current platform will be temporarily maintained for reference purposes.
0 votes
in Vehicle tracking by anonymous
I tested dallas sensors with fmb641 device, and all worked fine, so I installed sensors to trailer with fmc640. After that I cannot read sensors. Device doesn't detect sensors. What should I do? Add pullup resistor to data line or what to check. Wiring seems to be ok.

1 Answer

0 votes
by anonymous

We would like to analyze your case, therefore please open ticket in VIP Helpdesk and provide all needed information: device IMEI, firmware version, configuration file. If you don't have VIP Helpdesk login. please contact with your Sales Manager. If you don't have any contacts with our Sale managers, please contact with them on our official website and click on the "Contact Us" button. When you will click, please fill the form and submit it. Note: as a topic, please choose "Vehicle telematics".
Or you can send an e-mail with description of your situation to

Best Regards
by anonymous
Hi, First I will go on site with some oscilloscope for check what I will find on 1-wire data line, then I will back with results.
by anonymous
The solution is to use proper cable with low capacitance, and add additional pullup resistor betwen onewire VCC and onewire data line, I added about 3.8k and I'm able to connect sensors at 15m and at 30m on 30m length cable.
I hope it will run on site too.
by anonymous
Unfortunatelly 1-wire starts to drop data during last week.
Today I checked cables and I did not find nothing interested.
I don't have any ideas why it is not working.