Question

I've configured my FMC 920 as below:

Deep sleep timeout: 1 min
Data acquisition parameters: On stop: minimum period: 21600(6hrs) send period: 21600sec
open link timeout in gprs setting: 300sec
Now the device; having full battery; enters the Deep sleep mode perfectly [ after 1 minute of ignition+movement off ] the external power is disconnected after some time(say 10 minutes).

However, I expect it to send message after 6hrs which it has not.
Kindly advise where I'm wrong?

Answer 1

Hello.

Device don't send any records because send period is 21600 seconds.

Send period defines, how often device will check if Min. Records condition is met to send records.

I suggest to set it to lower value, 1-2 minutes

Regards

Comments

The device now sends message while in deep sleep mode. However, the location-which i'm more concerned about- is not included in the message send by device while in deep sleep. What could be the possible reason?

---

According to device protocol, GPS coordinates are always sent, it is not possible to send record without coordinates:

https://wiki.teltonika-gps.com/view/Teltonika_Data_Sending_Protocols