Question

I looking for some recomendations about installimg devices for reefer trailer. My concerns are about signal level of sensors from inside reefer chamder to outside where device is installed. And what are optimal sensors configurations in such case? I know more radio power and more frequent advertising equals short battery life.

Answer 1

Hello

To properly set the distance of detection of EYE Sensor by device

This should be done individually in the workplace if you do not want to use the maximum transmit power ( tx power) from the EYE sensor side .

It would require configuration of the operating range for communication via BLE 4.0- EYE SENSOR via adjust power signal ( tx power)  settings in EYE APP

details

https://wiki.teltonika-gps.com/view/EYE_SENSOR_/_BTSMP1#Eye_App_Overview

and in device configuration

Configurator => Bluetooth 4.0 => Common Settings => BT  Level

Best regards

Comments

Unfortunately EYE sensors not work in carrier reefer as expected.
Data are lost when split wall is set.

I set sensors to max power and 5s interval.
So looking for another solution.