Question

Hi,

I'm implementing driver identification using Teltonika Beacons. I am managing to release DOUT1 when the beacon is detected by the equipment. However, the Beacon data is sent in a separate packet from the others. I would like to know if there is a way to configure the equipment to send the beacon ID along with the other IO's, resulting in something like the following structure:

If this is not possible, I would like to know if it is possible to configure the equipment to send the beacon ID only when the

ignition is at high level.

Answer 1

Hello

AD1

Unfortunately, this is not possible, the Beacon will be sent in separate frames according to the Beacone mode settings

details

Beacon Mode

Simple – When simple mode is selected beacon parsing is done automatically (Eddystone and iBeacon protocols are supported) (AVL ID 385).

Advanced – When advanced beacon mode is selected, beacon data capturing can be configured manually (AVL ID 548).

AD2

You can use the function Beacone record=> Periodic

Record Period on Move > time

Record Period on STOP => 0

Set Source Movement => Ignition

You will only receive data during active ignition

details

https://wiki.teltonika-gps.com/view/FMB140_Beacon_List#Beacon_List_Settings_after_FW_ver._3.27.07.Rev.00

Best regards