Question

Hello, I'm trying to use the FMB 920 with the Fuel Level Sensor Escort TD-BLE ( https://www.fmeter.ru/en/produktsiya/besprovodnoy-datchik-urovnya-topliva/eskort-td-ble/).

I need to receive the ID (mac) from the sensor, but i dont know how to do this. In the end of  this link (https://wiki.teltonika-gps.com/view/FMB920_Bluetooth_4.0_settings) have an AVL Data but i dont recv a package like this just the values in the I/O elements.

I'm using this configs:

https://community.teltonika-gps.com/?qa=blob&qa_blobid=5041128047687696395 (sensors config)

With this config my FMB920 will request the data from the sensor each 120 seconds and put the data each 60seconds in the AVL data?
https://community.teltonika-gps.com/?qa=blob&qa_blobid=13636111480159897829

Answer 1

Hello,

Please check the following.

1. Codec 8 extended must be enabled.

2. Bluetooth should be enabled.

3. From the IO enable the Parameter for the BLE Temp, Fuel Level, and Battery Level or check in the configurator which IO is getting the parameter from the Fuel level sensor. -

4. Check for the AVL ID for that Particular IO - FMB920 Teltonika Data Sending Parameters ID - Wiki Knowledge Base | Teltonika GPS (teltonika-gps.com)

5. Make sure that you put the MAC address of the device in the Bluetooth 4.0 tab

For more info please check this link: How to connect Teltonika FMB tracker to wireless fuel level sensor Escort TD-BLE ? - YouTube

Best Regards,

Maynard C.

Comments

Thanks for the answer, but I need the MAC ID from the SENSOR, have some way to get the MAC ID of the SENSOR on the AVL-DATA?