Question

good afternoon. There was a question about the Teltonika fm 5000 terminal. When trying to reconfigure the server address using gprs commands, the commands are accepted, but the terminal continues to send data to the old server even after a reboot. how can this problem be fixed?

Answer 1

Hello.

To set targer server domain please use: setparam X245 your.server.addr

to set targer server port: setparam X246 port_number

X - profile number (default profile is 3)

Plase check this page:

https://teltonika-gps.com/product/fm5500/

at the bottom there is link to teltonika drive FM5500 folder.

You could download current firmware version, configurator and User Manual for FM5500.

Regards

Comments

thanks for your reply.  we set up profiles 1 and 2, and it was not obvious that the default is 3. now everything works.  thanks a lot again