Question

hello, i am sending getparam:100 to fmc130 device to check the value for movement source but it answer than "param ID:100 doesn't exist" and if i sending setparam 100:0 the fmc130 answer "warning: not supported param id" so, how can i change the movement source by sms to fmc130?

Answer 1

Hello,

Thank you for your question.

The Movement source parameter ID is 138, you should use command "getparam 138" to check value for movement source, and use command  "setparam 138:X" to set Movement source value, X - wanted Movement source value.

You can find more information about parameters here: https://wiki.teltonika-gps.com/view/Template:FMB_Device_Family_Parameter_list

Kind regards.

Comments

thank's for your answer, itś ok. adding comment:  change this link https://wiki.teltonika-gps.com/view/FMC130_Parameter_list#Home_Network_GSM_operator_code_.22Vehicle_MOVING.22_parameters because it show ID 100 as movement source