Question

I'm trying to integrate a FMB640 in a system I have. The system consists in an anntena that reads RFID tags, then the value read is sent via two cables Tx and GND in RS232 format. I want to read this value with the FMB640 and send it to my server. The problem is how to integrate the FMB640, because it has the RS232 input, should I create a cable to be able to connect the two cables to this Rs232 input? Where do I receive this value once it is read? The data sending parameters ID file does not specify this.

Answer 1

Hello Andres, 

Good day. Thank you for your question.

Please see the answers to your questions, below:

1) should I create a cable to be able to connect the two cables to this Rs232 input?

 - You will need to have an RJ45 cable in order for you to connect to the RS232 input. Please refer here for the connection diagram - https://wiki.teltonika-gps.com/view/FMB640_RS-232_and_RS-485

2) Where do I receive this value once it is read? The data sending parameters ID file does not specify this.

- If the RFID reader used is not supported then you can use TCP Binary/ASCII modes and receive data to the server in codec12. So if the If RFID HID or MF modes work then you will be able to see the values in I/O settings (see below).

Please go through this and let me know if it helps.

Kind regards.