FOR TIPS, gUIDES & TUTORIALS

subscribe to our Youtube

GO TO YOUTUBE

4167 questions

4739 answers

3460 comments

0 members

We are migrating to our new platform at https://community.teltonika.lt. Moving forward, you can continue discussions on this new platform. This current platform will be temporarily maintained for reference purposes.
0 votes
676 views
in Vehicle tracking by
Hi,

I want to enable my car to start only when my mobile phone is connected to my FMC130 via Bluetooth. Now I have set up a relay that would turn on via DOUT1 and allow my car to start but only when I get close to my mobile at a sufficient distance to connect to my FMC130 device. Is this possible and if so please explain how to do it.

Best regards,

Ivo

1 Answer

+1 vote
by anonymous
Hello

You can use the immobilizer scenario, here you will find additional information

https://wiki.teltonika-gps.com/view/FMB130_Features_settings#Immobilizer

You can use your smartphone with the Beacon Simulator application for authorization.

https://wiki.teltonika-gps.com/view/FMB130_Beacon_List

I hope you will be able to use this solution

Please verify

Best regards
by

Thank you for quick reply.

I download Android Application Beacon Simulator and I create two virtual beacons. I try to configure Immobilizer scenarios on my FMC130 but I never success to have high on DOUT2. In attachment photos of all configurations. i even try to put high and low to DIN1 but again DOUT2 is always OFF. Can you help me and tell we how to configure my Teltonika FMC130.

Best regards,

Ivo

by anonymous
Hello

Please see exactly how this scenario works

https://youtu.be/gjuiJjAejWU

Connect the relay-device-vehicle electrical system properly

In the next step, add your virtual Beacones to the Beacon List

https://wiki.teltonika-gps.com/view/FMB120_Beacon_List#Beacon_List.

If the device detects a Beacon before activating DIN1, you can start the vehicle. ( You do not activate  DOUT2 )

If you activate DIN1 earlier than the device detects your Beacon, you will need to bring it closer to the device to change the DOUT2 status through authorization and start the vehicle.

Best Regards
by

Hi,

I found the problem, I must to set DIN1 in Ignition source to ON.

Best regards,

Ivo