FOR TIPS, gUIDES & TUTORIALS

subscribe to our Youtube

GO TO YOUTUBE

4167 questions

4739 answers

3460 comments

0 members

We are migrating to our new platform at https://community.teltonika.lt. Moving forward, you can continue discussions on this new platform. This current platform will be temporarily maintained for reference purposes.
0 votes
949 views
in Vehicle tracking by
Is there config for Ruuvi sensor to get Teltonika FMB120/FMT100 etc work with that?

https://ruuvi.com/ruuvitag-specs/

1 Answer

0 votes
by anonymous

Hello,

We don't have predefined settings for Ruuvi sensors, but in Advanced mode it is possible to configure any Sensor that data can be received by FMB device.

https://wiki.teltonika-gps.com/view/FMB120_Bluetooth_4.0_settings#Advanced_Mode

To configure your sensor you need data frame specification, also very helpful is nRF application, where you could see raw data sent by BLE sensor, example below:

Regards

by

Any help from this?

Sorry about the first picture lines.. It´s how now config is made and not working.

by anonymous
Hello,

The picture is too small, and I can't see anything even if I magnify it is blurred. Please send better picture and screen from nRF application which example I haved showed you in previous message then I will try to help you with the sensor configuration.

Regards
by anonymous

Example how to get raw data from C MOV sensor in nRF:

by

I Changed bigger pictures above and here is these other pictures, hope these are better one.

by anonymous
Hello,

Please provide your sensor frame specification.
by
by anonymous

Hello,

I tried to explain your sensor frame in the below picture:

Please refer to BLE Sensors elements AVL ID:

https://wiki.teltonika-gps.com/view/FMB120_Teltonika_Data_Sending_Parameters_ID#BLE_Sensors_I.2FO_elements

Codec 8Extended should be enabled to read AVL ID’s above 255 (for example BLE 1 Custom#1 ->331)

temperature could be saved as BLE Temperature #(2 bytes)

Humidity could be as BLE Humidity #(2 bytes)

Pressure could be saved as BLE Luminosity# (2bytes)

Rest of sensor parameters should be saved as BLE Custom# (up to 256 bytes) ->first two bytes Accleration X, next two bytes acceleration Y, next two bytes acceleration Z, next two bytes Power info, next one byte movement counter

Example: