Question

Hello i want to see the status of the device FMB 640 on move every 4 minutes and on stop every 1 hour. The sms command to send is:

setparam

10000:3600;10004:1;10005:240;10050:240;10051:0;10052:0;10053:0;10054:1;10055:240;

10100:3600;10104:1;10105:240;10150:240;10151:0;10152:0;10153:0;10154:1;10155:240;

10200:3600;10204:1;10205:240;10250:240;10251:0;10252:0;10253:0;10254:1;10255:240

1. The command is right?

2. After the command need thew command setparam cpu reset?

3. How many time need to see the new values?

Answer 1

Hello,

Command is correct!

Don't forget to use two spaces in beginning or if you have set login and password for sms commands. Also make sure if there is less than 180 symbols in one message. After sending device should respond with new values. cpureset is not mandatory. Device will start recording data by these parameters that you changed immediately no need to wait certain time amount.

Hope all works!

Best regards,

Teltonika Support.