Question

Hello,

I have couple of problems with FMB120 and CAN-CONTROL

I am using FMB120 (fw. 03.25.15.Rev.01) with CAN-CONTROL  (Prog: 12226 SWDate: 190829 SWRev: 1 KernVer: 82) on Toyota Land Cruiser 150 2012. 

I can use lock and unlock my doors via lvcanopenalldoor and lvcanclosealldoors, but lvcanturninglights does not work and gives me the following error - CAN-CONTROL cmd executing error!

I can not get any FMB AVL ID for CAN ADAPTER described over here with "readio" SMS - https://wiki.teltonika.lt/view/FMB_AVL_ID#CAN_adapters_elements

I tested out some common ID's like Vehicle Speed (81), Accelerator Pedal Position (82), Fuel Consumed (83), etc but they all come back with Value: 0

I tested that Permanent I/O elements Ignition (239) works etc. but none of the CAN Adapter properties do ..

What might be the issues?

Answer 1

Hello,

Please double check wiring if polarity is not mixed and if correct PINs are used. Attaching PDF file: Click here

Check what possible controls can be on your vehicle model.

Hope this will help.

Best Regards,

Teltonika Support.