Question

HI, We have a big client that is using FMA120 NGP, the system in place is "GPS + Immobilizer + Identification". That demand is to "Start & Stop" vehicules remotely but unfortunatly, the "Start & Stop" option is not fonctionning on our devices because our immobilizer is on DOUT2 whereas the Start & Stop option commands the DOUT1. Is it possible to enable Start & Stop option to command the DOUT2?

Answer 1

Hello,

Thank you for your question.

You can use D_OUT2 for immobilizer function as long as you have configured the device to control D_OUT2 value. 

Schematics should be set according to an example: https://teltonika.lt/downloads/en/fmb120/FMB120-wiring-scheme-3.jpg

In your case you would have to change and configure your GPRS command structure to control D_OUT2 instead of D_OUT1 

For example SMS/GPRS command can set up for both Digital Outputs

setdigout ## Y1 Y2

Set digital output. 1.# – 0 or 1 (0 - OFF or 1 – ON) for DOUT1. 2.# – 0 or 1 (0 - OFF or 1 – ON) for DOUT2. Y1 – timeout value for DOUT1 if needed (in seconds). Y2 – timeout value for DOUT2 if needed (in seconds).

If D_OUT2 value is 1 means that immobilizer function is on if the value is 0 it has been set off.

Note that GPRS commands should be sent in Codec12 format.

More information on Codec12 can be found in the wiki:

https://wiki.teltonika.lt/view/Codec#Codec_12

Regards.

Comments

Hi Teltonika support,

thank you for your explanation but we need your assistance to enable the "Start/Stop vehicule" option via our plateforme " Geocal Fleet" to activate or di-activate DOUT2 because we had some feed back saying that option activates or di-activates only DOUT1. Is that possible?

Regards