FOR TIPS, gUIDES & TUTORIALS

subscribe to our Youtube

GO TO YOUTUBE

4167 questions

4739 answers

3460 comments

0 members

We are migrating to our new platform at https://community.teltonika.lt. Moving forward, you can continue discussions on this new platform. This current platform will be temporarily maintained for reference purposes.
0 votes
1,484 views
in Vehicle tracking by anonymous
Hello! we are new with Teltonika and we have some trouble with dallas temperature sensor. We use a 8m cable with a tested DS18b20 (works perfect with other tracker with one-wire input) and sometimes the sensor stop reading, or sends error 3000. If we reset the device, or disconnect and connect the sensor, it starts working again.

We need to solve this problem ASAP, or have to choose another gps device.

thank you very much !
by anonymous
Which FW version are you having trouble with?
by
Hello, we also have the same problem with the FM3612, the firmware is the latest available on 01.09.22.Rev: 0. Could someone help us?

3 Answers

0 votes
by anonymous
01.09.22 rev 0
0 votes
by
Please take log via USB cable using terminal. Log should start when device can read temperature and catch the moment when DS18B20 sensor stops sending data.
0 votes
by
We had the same problem and also if you unplug the device and plug it again it will burn your sensors. This happens because when the device powers up it sends to one wire power for half a sec 12 or 24 v depending on the power supply.

Now for the sensors if you are using 4 dallas make sure the folowing:

1 use 24 volts power supply (beter than 12) minimum 5A

2 Make sure the device has valid GPS signal

3 Use a resistor 2.2 KΩ between one wire power and one wire data (not4.7)

This should solve your problem

Make sure that you will connect a capacitor 100 mf (paralel connection ) between one wire power and GND for protecting the thermometers.

If you still facing any problem please do not hesitate to contuct us in order to help you

Hope it helped
by anonymous
Hello, can anyone technician from Teltonika, validate this solution or comment about the actual state of this issue or problem with the dallas temperature, we still facing this problem, any new firmware? or any new solution? The sensors work forn some time then only send 0 as temperature values. Waiting your kind response official from Teltonica, regards