Question

HI Everyone,

I have recently configured Teltonika FMB001 but i am not able to receive OBDII parameters i have tried Nodejs teltonika parser, traccar and one more but none of them was able to receive the OBD parameters though i am successfully receiving IO Elements with all of its attributes. Can you please guide if we are doing anything wrong in configuring anything during OBDII parameters in the device

Thanks

Ahmed

Answer 1

Hello,

Thank you for question.

Could you confirm that you are unable to read any of the parameters from the vehicle (when the engine is on) in the configurator? Parameters can be also checked remotely, when the vehicle engine is on send SMS command obdinfo. You should receive a response, description https://wiki.teltonika.lt/view/FMB_obdinfo

Have you set up your configuration correctly ? OBDII parameters should be set in the same matter as I/O, (Priority:Low/High/Panic) in order to send any OBDII data to server.

Is your vehicle using any of these following supported OBDII protocols:

1. SAE J1850 PWM (41.6 kbaud);
2. SAE J1850 VPW (10.4 kbaud);
3. ISO 9141-2 (5 baud init, 10.4 kbaud);
4. ISO 14230-4 KWP (5 baud init, 10.4 kbaud);
5. ISO 14230-4 KWP (fast init, 10.4 kbaud);
6. 15765-4 CAN (11 bit ID, 500 kbaud);
7. ISO 15765-4 CAN (29 bit ID, 500 kbaud);
8. ISO 15765-4 CAN (11 bit ID, 250 kbaud);
9. ISO 15765-4 CAN (29 bit ID, 250 kbaud).

Please provide us with more detailed info, so we could solve your issue easier.

Regards, Teltonika Support.

Comments

Hi,

We changed the car and we are successfully getting obdinfo result as following

{"result":"Prot:0,VIN:N/A,TM:30,CNT:0,ST:IDLE,P1:0xBC3FA803,P2:0x8005B001,P3:0x7AD00000,P4:0x0,MIL:0,DTC:0,ID1,Hdr:0,Phy:0"}

but when we try to send obd2info

we get OBD is Locked now

what does ODB locked now means ?

Thanks in advance