Question

Hello,

I have an ALL-CAN300 connected to an FMB640 and I would like to validate my setup and wiring in the lab. I would like to connect the CAN1 input of the ALL-CAN300 to an FMS simulator.
Is that possible? Is there a program number that accepts standard FMS protocol?

Answer 1

Hi there,

FMB640 has integrated can lines for FMS, you don't need AllCan300 adapter. User manual here https://wiki.teltonika.lt/view/FMB640

You can test it in lab as long you have necessary equipment to replicate FMS signals

Comments

Thank you for your reply.

I have already tested the FMB640 connected directly to the FMS simulator and that works fine.

However I need to install the device in a truck that does not have an FMS port, hence I need to use an AllCan300. At the moment I don't have access to the truck to validate the setup FMB640+AllCan, is there any way I can test this setup with an FMS simulator?