FOR TIPS, gUIDES & TUTORIALS

subscribe to our Youtube

GO TO YOUTUBE

4167 questions

4739 answers

3460 comments

0 members

We are migrating to our new platform at https://community.teltonika.lt. Moving forward, you can continue discussions on this new platform. This current platform will be temporarily maintained for reference purposes.
0 votes
326 views
in Vehicle tracking by anonymous
Hi I have fmb640 with LV can . When the vehicle is switched on the can mileage shows very little values. When it is switched on it will how 120km and after a few seconds it goes to the correct value of 301400km .. This makes my reports inacurate cause it shows my start mileage for the trip is 120km and the end mileage 301500km.

Everytime the car is switched of and on it takes a while to get the correct mileage.

How can I fix this?

1 Answer

0 votes
by anonymous
Hi,

Good day

which is the vehicle you are installed

only some particular vehicle?

kind regards,
by anonymous
AUDI A4 1.9TDI 2001 MODEL.

I have not yet tested on any other vehicles
by anonymous

for this vehicle do you have the program number? because if you use the wrong program number it will not get the correct value.

we have some schematic diagrams but for security reasons, we do not share any official file on the community forum as it is public.

there is another option also if you have fmb140 there is an auto-scan option so you can find the exact program number and parameters. 

if you are not able to get it, please reach out to us via VIP Helpdesk or contact your sales manager/distributor. If you don't have any contacts with our sales managers, please contact them on our official website https://teltonika-gps.com/ and click on the "Contact Us" button. When you will click, please fill out the form and submit it.

Note: as a topic, please choose "Vehicle telematics" or you can send an e-mail with the description of your situation to https://teltonika-iot-group.com/about-us/contacts/

Thank you for your understanding.

Kind regards.

by anonymous
I use 11132 . It gets the perfectly accurate mileage value but only after the ignition is on for a few seconds.

I have fmb640 so no auto scan
by anonymous

that program number for AUDI_A4_8E_2001, 

did you connect 2 can lines? 

which firmware is used from the can adaptor? if using old firmware should be updated with the new firmware

by anonymous

Yes 2 can wires connected. 

Prog:11132 SWDate:220406 SWRev:248 KernVer:5 Opt:10 ST:0x00 ID:0x0070007317203030