Hello,
i installed a FMB140 (with All-CAN config) with the CAN Lines to a DAF CF truck. I have set the CAN Program Number to 11465, saved config to device, load config to device and under "CAN Adapter -> Program number" i can see the 11465. Everything is working as expected.
Now i want to install it to a Fendt 828. Therefore i want to set the Program Number to 13148 or 12736 (for a Fendt 826). But if i do the above procedure, i always get the old Program Number. So the adapter is not accepting the new number. I also tried the Autoscan function, but it only shows one number, that seem to be incompatible.
I connected CAN1 to ISO Bus. I can also read the RPM of the engine. So communication is OK.
Does someone know, whats wrong?
In the Fendt tractor there is a ISO, K- and V- Bus. The FMB140 got 2 CAN interfaces. Can i connect CAN2 to K or V Bus to get more information?
I also wrote an email a week ago to info@teltonika.lt, but they didn't reply.
Thanks in advance.