Hi Team,
We are using the FMC640 to acquire CAN parameters for a J1939 capable engine. We need to monitor the following parameters
1. Engine Coolant Temperature (FEEE)
2. Engine RPM (F004)
3. Engine Total Hours of Operation (FEE5)
4. Engine Oil Pressure (FEEF)
5. Key Switch Battery Potential (FEF7)
6. Engine Percent Load (F003)
While some of these are configurable through the LVCAN option in the Teltonika.Configurator 1.7.4 B.FM64 R.12 as seen in the figure below:
The other will have to be manually configured through the Manual CAN IO option in the configurator as shown below (as these parameter are not present in LVCAN tab):
My doubt is whether enabling these partially in both LVCAN and Manual CAN IO would work ? or should I rather enable these 6 parameters in Manual CAN IO alone and leave LVCAN options disabled?
Regards,
Joseph