Hello SAKIS,
Good day. Thank you for your question.
Please go through the following steps:
On phone:
1) Enable the Blue Coin T using the Device Manager Mobile application and check via Bluetooth if you are able to view the temperature data and MAC address via the application itself.
2) If you are unable to view the MAC address on Device Manager Mobile, please install the nRF connect application and get the MAC address.
On Configurator:
3) Enable Codec 8 Extended on System > Data Protocol
4) Bluetooth tab > Enable(visible)/Enable(hidden)
5) Bluetooth 4.0 > Non Stop Scan > Disable > TZ-BT04/05/05B Update frequency : 30 seconds, BLE Scan Duration : 30 seconds, Scan retries until error : 30 seconds
6) Bluetooth 4.0 > BLE Connectionless Functionalities > Connection #1 > Advanced Mode > input the MAC address and select the Preset ELA T or ELA T x0.01
7) IO settings > Enable BLE Temperature #1 (Low/High Priority)
As a reference, you may also go through our Wiki page here -
https://wiki.teltonika-gps.com/view/How_to_start_with_FMB_devices_and_Beacons%3F
Ensure that before you perform this, the firmware used is the latest version. Currently, the latest version is FW03.27.07.Rev.00 (
https://wiki.teltonika-gps.com/view/FMB204_firmware_errata)
If you do not have the access to our Drive for firmware download, please reach out to us via VIP Helpdesk or contact your Sales Manager. If you don't have any contacts with our Sales managers, please contact them on our official website
https://teltonika-gps.com/ and click on the "Contact Us" button. When you will click, please fill the form and submit it.
Note: as a topic, please choose "Vehicle telematics" or you can send an e-mail with the description of your situation to info@teltonika.lt
Thank you in advance.
Kind regards.
