Question

Hello,

I am hoping someone can help? I have a couple of FMB920s which I am struggling to get into deep sleep mode. I have attempted to follow the instructions on the wiki but still cannot get my tracker to deep sleep.

The following link contains some screenshots of my configuration, please let me know if any additional screenshots are needed:

https://imgur.com/a/msIvFFq

I am connected to the tracker via bluetooth - am I right in thinking the device will still go into deep sleep while I am monitoring it via the I/O screen?

Answer 1

Hello

Thank you for question

Communication with the configurator via Bluetooth does not affect the transition to deep sleep mode.

Device need to also meet the conditions - below you will find a description

Please verify it

https://wiki.teltonika-gps.com/view/FMB920_Sleep_modes#Deep_Sleep_mode

Best regards

Comments

I have verified the details listed on the Wiki.

I don't think my device is going into 'On Stop' mode. I can see from the I/O section under status that movement is not detected nor is ignition detected (both showing '0'). I have changed the movement source to ignition (to rule out accelerometer detecting movement) but this does not seem to have helped.

Whatever settings I put into the 'On Stop' section of the 'Data Acquisition' section never seem to be used.

Any ideas?

---

Pay attention to the condition

Timeout time - in your case this is 60 minutes

Only after this time, the device will verify the remaining conditions

Pay attention to:

After Position Fix - FMB920 time is synchronized with GNSS satellites and GPS fix is obtained;

Best regards