Hello Kuser,
Good day. Thank you for your reply.
The MOV sensor detects motion and can send either 0 or 1 to the server regarding its state and you can configure this IO value as a high priority event.
It will be placed in the BLE # Custom IO slot depending on which sensor is configured. Operand should be on the entrance with intervals 1-1. Here, you can detect the movement and generate an alarm on the server-side or SMS can be sent to a phone. Regarding turning it on and off, you can disable that IO element when it is not needed via SMS command or GPRS command. If there would be an authorization with iButton or beacon in place, the server could just ignore movement detected on the sensor if the authorized driver is driving
Hope this clears your doubts.
Kind regards.