FOR TIPS, gUIDES & TUTORIALS

subscribe to our Youtube

GO TO YOUTUBE

4167 questions

4739 answers

3460 comments

0 members

We are migrating to our new platform at https://community.teltonika.lt. Moving forward, you can continue discussions on this new platform. This current platform will be temporarily maintained for reference purposes.
0 votes
208 views
in Vehicle tracking by

Hello, I have just bought a Fmb120, I use it on ultra deep sleep mode, as far as I'm concerned on this mode the device can not receive commands through GPRS unless it detects movements and the device can receive commands afterwards. When the device is still and on ultra deep sleep mode can the device get commands through SMS or something? or I always have to move it to activate it 

1 Answer

0 votes
by anonymous

Hello  علی کیانی, 

Good day. Thank you for your question.

While in deep sleep mode, FMB120 sets the GNSS receiver to sleep mode and turns off GSM/GPRS module (hence it is not possible to wake up the device via SMS). FMB120 exits ultra-deep sleep mode only when DIN1 or movement is detected by the accelerometer. Movement source and Ignition source configuration are not taken into account in this case. For more information, please refer at https://wiki.teltonika-gps.com/view/FMB120_Sleep_modes

Hope this clears your doubts

Kind regards.

by

  Thanks, after the vehicle stops,how much time do I have to send my command before the device turns to ultra mode? 

by anonymous

Hello there, 

Thank you for your reply.

This depends on the timeout that you have set, and the device only goes to sleep when all the conditions are met as in the link I have shared earlier. (https://wiki.teltonika-gps.com/view/FMB120_Sleep_modes)

Hope this helps.

Kind regards.