I'm connecting an RFID reader with RS232 to FM125 but facing issue that the values are not being set into RFID I/O altogether but are available in Maintenance tab correctly in RS232/485 section.
Following are the details
FMM125
Firmware 03.25.15 Rev:88
RFID Settings
Mode: RS232
RS232 Mode: RFID MF7
Baud Rate: 9600
FMM125 RS232 Value in Maintenance Tab
Correct HEX values are read in RS232 but is not set as RFID value in IO
RFID Value is not set
Same settings when tested with FMB640, correct values are read and set in RFID.
Any ideas on solving this issue.