Question

Hello,

I have a litte problem with FMB140 (FW 03.25.11 Rev: 144). Directly with ignition from engine RPM.
I connected device to CAN, device reads correctly data (engine RPM):

I configured device (system/ignition source/Engine RPM):

Of course, I saved the configuration.

But device not recognize ignition:

Did I set something wrong or is it a software error?

Thank you for the advices.

lukasha

Answer 1

Hi,

Can you please upload the terminal log file from the device ?

You can use google drive to upload.

Thanks in advance

Naveen

Comments

This is a log file:

file:

https://drive.google.com/file/d/1DEMlsrA1VXfHWxClkLSBqhTBI8Ol_0qJ/view?usp=sharing

Thanks!

Lukasha

Answer 2

This is a log file:

file:

https://drive.google.com/file/d/1DEMlsrA1VXfHWxClkLSBqhTBI8Ol_0qJ/view?usp=sharing

Thanks!

Lukasha

Answer 3

Hi,

I can't find any events in your log, Can you please create some events and capture the log ?

While capturing the log, start and stop engine.

Please make ignition as high priority event.

I don't have FMB140 configurator, So I couldn't check your cfg file.

Make sure your settings are saved in the device.

Thanks

Naveen

Answer 4

I do it.

I set the event:

I set high ptiority:

CAN configuration looks like this:

Ofcoruse I saved configuration.

Log is here:

https://drive.google.com/open?id=1yLezZJFFR9ZgvUYDtBTrKBxp6EK8o27N

Maybe FMB140 takes RPM from OBD, not from CAN? If this is the case then it should be corrected in the firmware.

Lukasha

Answer 5

Teltonika, can You help?

Lukasha